| Performance |
AC testing was performed at 1 kHz. |
| Frequency Response, DC€”100 kHz (1 watt) |
+0.0 to -3.0 dB |
| 8-Ohm Power Response (continuous duty) |
DC to 60 kHz |
± 140 Vpk |
| DC to 100 kHz |
± 50 Vpk |
| Slew Rate |
50 V/μSec |
| Residual Noise |
10 Hz to 300 kHz |
950 μV (0.95 mV) |
| 10 Hz to 80 kHz |
300 μV (0.3 mV) |
| Signal-to-Noise Ratio |
10 Hz - 30 kHz |
-113 dB |
| 10 Hz - 80 kHz |
-106.6 dB |
| Unit to Unit Phase Error |
±0.1 degrees at 60 Hz |
| THD (DC - 30 kHz) |
<0.1% |
| Output Offset |
<±5 mV, field adjustable to less than 1 mV |
| DC Drift |
<±1.5 mV |
| Output Impedance |
5.3 mOhm in Series with 0.95 μH |
| Phase Response (10 Hz - 10 kHz) |
±5 degrees plus 560 nsec propagation delay |
| Input Characteristics |
Balanced with ground |
Three terminal barrier block connector, 20k ohm differential |
| Unbalanced |
BNC connector, 10k ohm single ended |
| Gain (variable or fixed) |
Voltage Mode |
20 volts/volt |
| |
Current Mode |
5 amperes/volt |
| Gain Linearity (over input signal, from 0.2V to 5V) |
0.15% |
| Max Input Voltage |
±10V, balanced or unbalanced |
| Input Impedance |
20k ohm differential |
| Common Mode Rejection |
-58 dB with 5V input |
| Display, Control, Status, I/O |
| Front Panel LED Displays indicate |
Ready, Standby, Fault, Over Temp, Over Voltage, Overload |
| Soft Touch Switches for |
Run, Stop, Reset |
| Gain Control, when enabled |
Voltage gain adjustable from 20 to 0 |
| On/Off Breaker |
| Back Panel Power Connection |
25 Amp IEC (with retention latch) |
| Signal Output |
Three-position terminal strip (OUTPUT/COM/CHASSIS GROUND); resistor between COM and CHASSIS GROUND terminals is a 2.7-ohm, 2W, 5%, metal-oxide resistor |
| Signal Input |
User-selectable BNC or Barrier Strip, Balanced or Unbalanced |
| Communication Capabilities |
| Current Monitor |
5A/V ± 1%; 2.5A/V ± 1% (differential configuration) |
| Reporting |
System Fault, Over Temp, Over Voltage, Over Load |
| Remote Control via Interlock Connector |
Force to Standby, Reset after a Fault |
| Physical Characteristics |
| Chassis |
The Amplifier is designed for stand- alone or rack-mounted operation. The Chassis is black aluminum with a powder coat finish. The unit occupies two EIA 19-inch-wide units. |
| Weight |
35 lbs (15.9 kg), Shipping 45 lbs (20.4 kg) |
| AC Power |
Single phase, 120 VAC, 60 Hz, 20A service; (220-240 VAC, 50-60 Hz, 10A service model available) |
| Operating Temperature |
10°C to 50°C (50°F to 122°F), maximum output Power de-rated above 30°C (86°F).) |
| Humidity |
70% or less, non-condensing |
| Cooling |
Forced air cooling from front to back through removable filters. |
| Airflow |
180CFM |
| Dimensions |
19 in. x 22.75 in. x 3.5 in. (48.3 cm x 57.8 cm x 8.9 cm) |
| Protection |
| Over/Under Voltage |
± 10% from specified supply voltage amplifier is forced to Standby |
| Over Current |
Breaker protection on both main power and low voltage supplies |
| Over Temperature |
Separate output transistor, heat sink, and transformer temperature monitoring and protection |
![](javascript:addcart({"pid":915,"pname":"Rohde & Schwarz BBL200-series Broadband Amplifier 9 kHz - 225 MHz up to 10kW","image":"/uploads/2019/04/rs_bba200.png"})){kind=link}
![](javascript:addcart({"pid":914,"pname":"Rohde & Schwarz BBA150-series Broadband Amplifiers 4 kHz - 6 GHz up to 3000W","image":"/uploads/2019/04/rs_bba150.png"})){kind=link}
![](javascript:addcart({"pid":913,"pname":"Rohde & Schwarz BBA130-series Broadband Amplifiers 80 MHz - 6 GHz up to 4200W","image":"/uploads/2019/04/rs_bba130.png"})){kind=link}
![](javascript:addcart({"pid":41,"pname":"AE Techron 7700-series EMC Amplifiers DC - 30 kHz, 5 - 20kW","image":"/uploads/2019/02/ae_techron_7700-series.png"})){kind=link}
![](javascript:addcart({"pid":40,"pname":"AE Techron 7220-series EMC Amplifiers DC - 1 MHz 1000W","image":"/uploads/2019/02/ae_techron_7220-series.png"})){kind=link}
![](javascript:addcart({"pid":39,"pname":"AE Techron 7136 High-speed AC/DC Amplifier","image":"/uploads/2019/02/ae_techron_7136.png"})){kind=link}
![](javascript:addcart({"pid":38,"pname":"AE Techron 7114 High-speed AC/DC Amplifier","image":"/uploads/2019/02/ae_techron_7114.png"})){kind=link}
![](javascript:addcart({"pid":36,"pname":"AE Techron 7100-series High-Speed AC/DC Amplifiers","image":"/uploads/2019/02/ae_techron_7100-series.png"})){kind=link}
![](javascript:addcart({"pid":1416,"pname":"Teseq CBA 6G-120B Broadband Amplifier 1.8 GHz - 6 GHz 120W","image":"/uploads/2018/01/teseq_cba_6g-120b.png"})){kind=link}
![](javascript:addcart({"pid":1415,"pname":"Teseq CBA 6G-080B Broadband Amplifier 1.8 GHz - 6 GHz 80W","image":"/uploads/2018/01/teseq_cba_6g-080b.png"})){kind=link}
![](javascript:addcart({"pid":1414,"pname":"Teseq CBA 6G-040B Broadband Amplifier 1.8 GHz - 6 GHz 40W","image":"/uploads/2018/01/teseq_cba_6g-040b.png"})){kind=link}
![](javascript:addcart({"pid":1413,"pname":"Teseq CBA 3G-500B Broadband Amplifier 800 MHz - 3.1 GHz 500W","image":"/uploads/2018/01/Image_Placeholder.png"})){kind=link}