Display Type

Transflective LCD, monochrome

Display Size

10 cm (4 inch), resolution 240 x 320 dots

Backlight

White LEDs, selectable illumination time (OFF, 5s, 10s, 30s, 60s, PERMANENT)

Refresh Rate

200 ms for bar graph and graphics, 400 ms for numerical results

MEASUREMENT FUNCTIONS

Result Units

mW/cm2, W/m2, V/m, A/m, % of Standard

Display Range, Fixed Triads

0.0001 to 9999 for all units (4 digits)

Display Range, Variable Triads

0.01 V/m to 100 kV/m0.027 mA/m to 265.3 A/m0.265 μW/m2 to 26.53 MW/m2 0.027 nW/cm2 to 2.653 kW/cm2 0.0001% to 9999%

Result Types (Isotropic, RSS)

Actual (ACT), Maximum (MAX), Minimum( MIN), Average (AVG), Maximum Average (MAX AVG)

Result Types (X-Y-Z mode)

Actual X, Actual Y, Actual Z (requires a probe with separate axes)

Averaging Time

Selectable, 4 seconds to 30 minutes (2 second steps)

Spatial Averaging

Discrete or continuously

Multi-position Spatial Averaging

Averaging of up to 24 spatially averaged results, each position and total will be stored

History View

Graphical display of actual results versus time (span of 2 minutes to 8 hours)

Frequency Correction

1 kHz to 100 GHz or OFF (direct frequency entry, interpolation between calibration points)

Hot Spot Search

Audible indicator for increasing and decreasing field strength (result type Act or Max)

Alarm Function

2 kHz audible signal (4 Hz repetition), adjustable threshold

Timer Logging

Start time pre-selection: up to 24 hours or immediatelyLogging duration: up to 100 hoursLogging interval: 1 second to 6 minutes (in 11 steps)

RESULTS MEMORY

Physical Memory

12 MB non-volatile flash memory for measurement results and voice comments

Storing Capacity

Up to 5000 results (including test parameters, time stamp and GPS data when available)

INTERFACES

Remote Control

Via USB or optical RS-232 interface (selectable)

USB

Serial, full duplex, 460 kBaud (virtual COM port), multi-pin connector

Optical Interface

Serial, full duplex, 115 kBaud, no parity, 1 start and 1 stop bit

Earphone

3.5 mm TRS, > 16 ohms (mono), for voice recorder option only

External Trigger (to store results)

Uses the multi-pin connector. Interface cable with BNC connector available as an option, triggers when contacts shorted.

External GPS Receiver

Uses the multi-pin connector. GPS receiver with interface cable is available as an option

Probe Interface

Plug-and-play auto detection, compatible with all NBM series probes