MIL-STD 461 CE102

DEPARTMENT OF DEFENSE INTERFACE STANDARD

MIL-STD 461 CE102 Conducted Emissions, Radio Frequency Potential, Power Leads

This test procedure is used to verify that electromagnetic emissions from the EUT do not exceed the specified requirements for power input leads, including returns.

Applicability

This requirement is applicable from 10 kHz to 10 MHz for all power leads, including returns, which obtain power from other sources not part of the EUT.

Limits

Conducted emissions on power leads shall not exceed the applicable values shown on Figure CE102-1.

Test Equipment

    
 	
  1. Measurement receiver
    2. 
 	
  2. Data recording device
    3. 
 	
  3. Signal generator
    4. 
 	
  4. Attenuator, 20 dB, 50 ohm
    5. 
 	
  5. Oscilloscope
    6. 
 	
  6. LISNs
    7. 


Preview Standard
}