| Performance |
| Frequency Response |
DC to 10 kHz driving a 0.25-ohm load |
| Maximum Output Current |
70 Arms, 100 Apeak, 0.5 ohms |
| Maximum Output Voltage |
195 Vpeak |
| Maximum Output Power |
Dependent on load and frequency |
| Load Constraint for Maximum Output |
0.5 ohms + 200 microhenries |
| Output Offset Current |
Less than 10.0 milliamperes DC peak |
| Unit to Unit Phase Error |
± 0.1 degrees at 60 Hz |
| Residual Noise |
Less than 2.5 milliamperes peak (40Hz - 600Hz) |
| Out Accuracy |
Less than ±1% |
| Input Characteristics |
| Balanced with ground |
Three terminal barrier block connector 20 k ohm differential |
| Unbalanced |
BNC connector, 10 k ohm single ended |
| Standard Gain |
Switchable 10 amps/volt (+0.2%) or 2 amps/volt (+0.2%) |
| Standard Transconductance |
20 ±0.2% from short to 1-ohm loads |
| Max Input Voltage |
± 10 V balanced or unbalanced |
| Input Impedance |
20 kOhm differential |
| Input Sensitivity |
3.0V input for 3800W output into 1 ohm (adjustable) |
| Common Mode Rejection Ratio |
-58 dB minimum, 40-600Hz |
| Display, Control, Status, I/O |
| Front Panel LED Displays Indicate |
Run, Ready, Standby, Stop, and Fault conditions in the output stage |
| LCD Display |
Lists type of fault condition and gives suggested corrective action |
| Soft-Touch Switches for |
Run (Enable), Stop, Reset |
| User Configurable |
LCD display can be configured for up to four simultaneous displays reporting one, two or all four of the following: Voltage Peak, Voltage RMS, Current Peak, and Current RMS |
| Back Panel Power Connection |
NEMA-style locking receptacle; matching AC connector also included |
| Signal Output |
4-position terminal barrier block |
| Signal Input |
User-selectable Unbalanced BNC or Balanced Barrier Strip |
| Interlock Connector |
25-pin D-sub connector used for amplifier control and status applications; also used in multi-amplifier applications |
| Communication Capabilities |
| Current Monitor |
± 1V / 20A ±1% |
| Reporting |
System Fault, OverTemp, Over Voltage, Overload |
| Control |
Force to Standby; Reset after a fault |
| Protection |
| Over/Under Voltage |
± 10% from specified supply voltage amplifier is forced to Standby |
| Over Current |
Breaker protection on both main power and low voltage supplies |
| Over Temperature |
Separate Output transistor, heat sink, and transformer temperature monitoring and protection |
| Physical Characteristics |
| Chassis |
Black powder-coat chassis with all aluminum construction; designed for stand-alone or rack-mounted operation. The amplifier occupies five EIA 19-inch-wide rack units |
| Weight |
110 lbs. (50 kg) |
| AC Power |
Three-phase, 208 VAC ±10%, 47-60 Hz, 20A AC service (400 VAC ±10%, 15A version available). A toggle switch circuit breaker opens all legs of the AC mains on excess current demand. |
| Operating Temperature |
10°C to 50°C (50°F to 122°F), Maximum Output Power de-rated above 30°C (86°F) |
| Humidity |
70% or less, non-condensing |
| Cooling |
Forced air-cooling from front to back through removable filters via four 100 ft3/min. fans. No space is required between rack-mounted amplifiers. Air filters are removable from the rear via one fastener per side and may be eliminated if cabinet filtration is provided. |
| Dimensions |
19 in. x 22.8 in. x 8.75 in. (48.3 cm x 57.9 cm x 22.3 cm). |
![](javascript:addcart({"pid":915,"pname":"Rohde & Schwarz BBL200-series Broadband Amplifier 9 kHz - 225 MHz up to 10kW","image":"/uploads/2019/04/rs_bba200.png"})){kind=link}
![](javascript:addcart({"pid":914,"pname":"Rohde & Schwarz BBA150-series Broadband Amplifiers 4 kHz - 6 GHz up to 3000W","image":"/uploads/2019/04/rs_bba150.png"})){kind=link}
![](javascript:addcart({"pid":913,"pname":"Rohde & Schwarz BBA130-series Broadband Amplifiers 80 MHz - 6 GHz up to 4200W","image":"/uploads/2019/04/rs_bba130.png"})){kind=link}
![](javascript:addcart({"pid":41,"pname":"AE Techron 7700-series EMC Amplifiers DC - 30 kHz, 5 - 20kW","image":"/uploads/2019/02/ae_techron_7700-series.png"})){kind=link}
![](javascript:addcart({"pid":40,"pname":"AE Techron 7220-series EMC Amplifiers DC - 1 MHz 1000W","image":"/uploads/2019/02/ae_techron_7220-series.png"})){kind=link}
![](javascript:addcart({"pid":39,"pname":"AE Techron 7136 High-speed AC/DC Amplifier","image":"/uploads/2019/02/ae_techron_7136.png"})){kind=link}
![](javascript:addcart({"pid":38,"pname":"AE Techron 7114 High-speed AC/DC Amplifier","image":"/uploads/2019/02/ae_techron_7114.png"})){kind=link}
![](javascript:addcart({"pid":36,"pname":"AE Techron 7100-series High-Speed AC/DC Amplifiers","image":"/uploads/2019/02/ae_techron_7100-series.png"})){kind=link}