| Performance |
| Maximum Output Current |
200 amps peak |
| Maximum Output Voltage |
183 volts peak |
| Maximum Output Power |
Dependent on load and frequency |
| Load Constraint for Maximum Output |
0.19 ohms + 200 microhenries |
| Output Impedance |
Greater than 250 ohms at 60 Hz |
| Output Offset Current |
Less than 10.0 milliamperes DC peak |
| Unit to Unit Phase Error |
± 0.1 degrees at 60 Hz |
| Residual Noise |
Less than 2.5 milliamperes peak (40Hz - 600Hz) |
| THD+N: |
Less than 0.10% at 600 Hz, full output power |
| Input Characteristics |
| Balanced with ground |
Three terminal barrier block connector 20 k ohm differential |
| Unbalanced |
BNC connector, 10k ohm single ended. |
| Gain |
40 amps/volt (+0.2%) |
| Common Mode Rejection Ratio |
-58 dB minimum, 40-600 Hz |
| Display, Control, Status, I/O |
| Front Panel LED Displays indicate |
Ready, Standby, Fault, Over Temp, Over Voltage, Overload |
| Front Panel LCD Display |
User-configurable for up to four simultaneous displays reporting one, two, or all four of the following: Voltage Peak, Voltage RMS, Current Peak, and Current RMS. If an amplifier fault condition occurs, the front panel display lists the type of fault condition and gives suggested corrective action. |
| Soft Touch Switches for |
Run, Stop, Reset |
| Gain Control, when enabled |
Voltage gain adjustable from 20 to 0 |
| On/Off Breaker |
| Back Panel Power Connection |
25 Amp IEC (with retention latch) |
| Signal Output |
+/Common/Sampled Common |
| Signal Input |
User Selectable BNC Unbalanced or Barrier Strip Balanced |
| Communication Capabilities |
| Current Monitor |
± 1 V / 6 A ± 1% |
| Input Signal Monitor |
± 1 V / 2 V ± 1% |
| Reporting |
System Fault, Over Temp, Over Voltage, Over Load |
| Control |
Force to Standby, Reset after a Fault |
| Protection |
| Over/Under Voltage |
±10% (±5% for 400VAC version) from specified supply voltage amplifier is forced to Standby |
| Over Current |
Breaker protection on both main power and low voltage supplies |
| Over Temperature |
Separate output transistor, heat sink, and transformer temperature monitoring and protection |
| Physical Characteristics |
| Chassis |
The Amplifier is designed for stand-alone or rack-mounted operation. The Chassis is aluminum with a black powder coat finish. The unit occupies seven EIA 19-inch-wide units. |
| Weight |
160 lbs (72.5 kg) |
| AC Power |
Three-phase, 208 VAC ±10%, 47-60 Hz, 30 Amp service; 400 VAC (±5%) 47-60 Hz, 15 Amp version available. A toggle switch circuit breaker opens all legs of the AC mains on excess current demand. |
| Operating Temperature |
10°C to 50°C (50°F to 122°F), Maximum Output Power de-rated above 30°C (86°F).) |
| Humidity |
70% or less, non-condensing |
| Cooling |
Forced air cooling from front to back through removable filters. |
| Dimensions |
19“ x 22.8“ x 12.25“ (48.3 cm x 57.8 cm x 31.1 cm) |
![](javascript:addcart({"pid":915,"pname":"Rohde & Schwarz BBL200-series Broadband Amplifier 9 kHz - 225 MHz up to 10kW","image":"/uploads/2019/04/rs_bba200.png"})){kind=link}
![](javascript:addcart({"pid":914,"pname":"Rohde & Schwarz BBA150-series Broadband Amplifiers 4 kHz - 6 GHz up to 3000W","image":"/uploads/2019/04/rs_bba150.png"})){kind=link}
![](javascript:addcart({"pid":913,"pname":"Rohde & Schwarz BBA130-series Broadband Amplifiers 80 MHz - 6 GHz up to 4200W","image":"/uploads/2019/04/rs_bba130.png"})){kind=link}
![](javascript:addcart({"pid":41,"pname":"AE Techron 7700-series EMC Amplifiers DC - 30 kHz, 5 - 20kW","image":"/uploads/2019/02/ae_techron_7700-series.png"})){kind=link}
![](javascript:addcart({"pid":40,"pname":"AE Techron 7220-series EMC Amplifiers DC - 1 MHz 1000W","image":"/uploads/2019/02/ae_techron_7220-series.png"})){kind=link}
![](javascript:addcart({"pid":39,"pname":"AE Techron 7136 High-speed AC/DC Amplifier","image":"/uploads/2019/02/ae_techron_7136.png"})){kind=link}
![](javascript:addcart({"pid":38,"pname":"AE Techron 7114 High-speed AC/DC Amplifier","image":"/uploads/2019/02/ae_techron_7114.png"})){kind=link}
![](javascript:addcart({"pid":36,"pname":"AE Techron 7100-series High-Speed AC/DC Amplifiers","image":"/uploads/2019/02/ae_techron_7100-series.png"})){kind=link}
![](javascript:addcart({"pid":1409,"pname":"Teseq CBA 1G-1200B Broadband Amplifier 80 MHz - 1 GHz 1200W","image":"/uploads/2018/01/Image_Placeholder.png"})){kind=link}